Audio ยท WAV to MP3
WAV to MP3 converter with bitrate and VBR.
Shrink WAV recordings and exports into MP3. Choose a constant bitrate or LAME variable-bitrate quality, set the sample rate and channels, and convert up to ten files in one pass without uploading anything.
How much smaller does a WAV get as an MP3?
An uncompressed CD-quality WAV (44.1 kHz, 16-bit, stereo) is 1,411 kbps, which is 10.58 MB for every minute. A 192 kbps MP3 of the same minute is 1.44 MB, about one seventh the size. At 128 kbps it is 0.96 MB and at the 320 kbps ceiling it is 2.4 MB. The arithmetic is simple: kilobits per second × 1,000 ÷ 8 × seconds. The audio file size calculator does it for any sample rate and bit depth.
That shrinkage is the point of the format, and it has a price: MP3 throws away detail that listeners are least likely to notice. Keep the WAV if you may edit, remaster or re-export the audio later; send or publish the MP3.
Constant bitrate or VBR?
Constant bitrate is the safe default for anything with a size limit, because the file size is the bitrate times the length. 128 kbps suits speech and casual listening, 192 kbps is a good music default, 256 and 320 kbps are for material you care about.
Variable bitrate uses the LAME quality scale, where V0 is the highest quality and V9 the lowest. Quiet or simple stretches get fewer bits, dense passages get more. Pick VBR when you care about quality per megabyte and the destination does not need a fixed rate. A few very old hardware players handle VBR files badly; if one stutters, redo the file as constant bitrate.
Sample rate and channels are optional. Leave them alone for music. Dropping a speech recording to 22.05 kHz mono at 64 kbps makes a file that is a small fraction of the original and still clear. If you request more bitrate than the sample rate allows, the tool lowers it to the format maximum (160 kbps at 22.05 kHz, 64 kbps at 8 kHz) and the result card shows the bitrate actually used.
What the converter accepts
Any PCM WAV: 8, 16, 24 or 32-bit integer, or 32-bit floating point, mono through multichannel. A multichannel file is mixed down by the encoder to what MP3 supports (mono or stereo), so check that result by ear. Rates above 48 kHz, such as 96 kHz studio files, are converted to a rate MP3 can store, 48 kHz unless you pick another.
The tool goes by file name: only .wav and .wave files are accepted, which keeps a stray video or document from reaching the encoder. A file with a .wav name but other contents is read by what is inside it and fails with a clear message if it holds no audio.
Worked example
A podcast guest sent a 58-minute WAV of 44.1 kHz, 16-bit stereo, about 614 MB. That is over this tool’s 300 MB per-file limit, so split it in your editor first or export mono, which halves it. A 20-minute segment is about 212 MB. Convert it at 128 kbps CBR, mono, and the MP3 is 19.2 MB (16,000 bytes per second × 1,200 s).
Limits and common mistakes
- Ten files per run, 300 MB each. Files over the limit are skipped with a message.
- Choosing 320 kbps does not make a quiet, noisy or clipped recording sound better. It only makes a bigger file.
- MP3 cannot store 24-bit depth or sample rates above 48 kHz; the encoder works from the decoded audio at its own precision, so very small level differences are lost.
- Metadata inside a WAV (a LIST chunk) is not copied unless you tick the tags box, and most WAV files carry none.
- Each file downloads separately, so your browser may ask permission to save several.
Privacy: what the code does
The tool runs in a sandboxed frame with no network access. Your WAV is read by the browser, passed to a WebAssembly build of FFmpeg with the LAME MP3 encoder, and returned as a download from your own device. There is no upload step and no server that could keep a copy. Reload the page and everything is gone.
Common mix-ups
-
Often assumedA 320 kbps MP3 is the same as the WAV it came from.
What the source saysMDN's codec guide says lossy compression always loses some fidelity. MP3 is lossy, so even a high bit rate is a trade for file size; keep the WAV as the master copy. [1]
-
Often assumedA WAV file is already compressed, so an MP3 made from it is a small step.
What the source saysMDN says nearly all WAV files use linear PCM, which is uncompressed. MP3 compression therefore does a large share of the work, and MDN lists compression of up to 80 to 95 percent as possible for lossy audio. [2]
Checked against these sources on .
Frequently asked questions
What bitrate should I use to convert WAV to MP3?
192 kbps is a good all-round choice for music, 128 kbps is fine for speech, and 320 kbps is the maximum for MP3. VBR V2 is a common music setting, and its bitrate floats with the audio.
Can I convert a WAV to MP3 without uploading it?
Yes. The conversion runs in your browser with FFmpeg compiled to WebAssembly, and the tool frame has no network access, so the file never leaves your device.
How much space will I save?
About 86 percent at 192 kbps for CD-quality stereo: 10.58 MB per minute becomes 1.44 MB. The result card shows the real before and after sizes for each file.
What does VBR V0 to V9 mean?
It is the LAME quality scale for variable bitrate encoding. V0 is the highest quality and largest, V9 the lowest and smallest. The bitrate floats with the audio.
Why was my bitrate lowered?
MP3 allows only certain bitrates for each sample rate. At 22.05 kHz the maximum is 160 kbps and at 8 kHz it is 64 kbps, so higher requests are reduced.
Will 24-bit or 96 kHz WAV files work?
Yes. They are decoded in full and written as an MP3 at a supported rate, 48 kHz at most. The extra bit depth is not stored in the MP3.
Is converting back to WAV the same as the original?
No. MP3 is lossy, so a WAV made from the MP3 is larger than the MP3 but still lacks what the encoder discarded. Keep the original WAV.
Does it work offline?
After the page and the audio engine have loaded once, conversion itself needs no connection, because everything runs inside the tab.
Sources
Standards and documentation behind the claims on this page.
- WAVE Audio File Format (Library of Congress) (retrieved 2026-10-20): WAVE as a RIFF-based, usually uncompressed PCM audio format.
- LAME: variable bit rate (retrieved 2026-10-20): VBR quality scale from -V 0 (highest) to -V 9 (lowest).
- MP3 (Wikipedia) (retrieved 2026-10-20): MPEG-1, MPEG-2 and MPEG-2.5 layer III sample rates and bitrates.
- FFmpeg codecs documentation (retrieved 2026-10-20): libmp3lame bitrate and quality options.
- Compact Disc Digital Audio (Wikipedia) (retrieved 2026-10-20): CD audio is 44.1 kHz, 16-bit stereo, which is 1,411 kbps.
What this tool does not do
It does not restore detail lost in a poor recording, keep WAV bit depth above what MP3 stores, or upload your files anywhere. Lossy formats (MP3, AAC, Ogg) discard information, so keep your originals.