Food · Holidays 2026

Prime rib roast calculator.

Enter the weight, bone-in or boneless, and when you want to carve. The tool gives the USDA time range and the oven window.

Short answer: USDA FSIS lists a bone-in rib roast at 325 °F for 23 to 30 minutes per pound (4 to 8 lb) and a boneless 4 lb rib roast at 39 to 43 minutes per pound. Cook to at least 145 °F on a food thermometer, then rest at least 3 minutes.

Source: USDA FSIS Holiday Meat Roasting ChartRetrieved October 26, 2026

Advertisement

Your roast

Enter the clock time you want to start carving, for example 18:00.

USDA asks for at least 3 minutes. A longer rest is your choice.

Result

Enter your details and press Calculate.

Advertisement

What the USDA chart gives you

The Food Safety and Inspection Service publishes a holiday meat roasting chart that lists oven temperature, timing and minimum internal temperature for roasts you are likely to buy in December. For beef rib roasts it gives two rows. A bone-in rib roast of 4 to 8 pounds goes in a 325 °F oven for 23 to 30 minutes per pound. A boneless rib roast, listed at 4 pounds, takes 39 to 43 minutes per pound. The bone-in row is a wide range, and the chart calls the figures approximate cooking times for meal planning.

The same page sets the safety rule: cook beef steaks, roasts and chops to a minimum internal temperature of 145 °F as measured with a food thermometer before removing the meat from the heat source, then allow it to rest for at least three minutes before carving. People may choose a higher temperature for personal preference. FSIS also advises against roasting meat in ovens set below 325 °F.

Why the start-time window is a window

With a range of 23 to 30 minutes per pound, a 6 lb roast spans 42 minutes of uncertainty. The calculator counts back from the carving time you enter, subtracting the rest, and shows both ends: the latest time you can put the roast in if it cooks at the fast end, and the earliest if it cooks at the slow end. Put it in at the early end if you would rather hold a finished roast than rush dinner. The thermometer decides when it is done, not the clock.

Worked example

A 6 lb bone-in roast at 325 °F: 6 × 23 = 138 minutes (2 h 18 min) to 6 × 30 = 180 minutes (3 h 00 min). To carve at 6:00 pm after the 3-minute minimum rest, the roast goes in between 2:57 pm (slow end) and 3:39 pm (fast end). A 4 lb boneless roast is 4 × 39 = 156 to 4 × 43 = 172 minutes. Weights outside the chart's rows, such as a 10 lb bone-in roast, get a warning, because the chart does not cover them.

Sources and how this is calculated

Minutes = pounds × the chart's minutes per pound, low and high. Start window = serve time − rest − high minutes, and serve time − rest − low minutes. Retrieved October 26, 2026. The chart lists one boneless weight, so a boneless roast of a different size is a rougher estimate. FSIS's older beef pages give different per-pound figures; this page follows the holiday roasting chart.

Advertisement

Common mix-ups

  1. USDA FSIS: Roasting Those Other Holiday Meats (holiday meat roasting chart)

Checked against these sources on .

Frequently asked questions

How long does it take to cook a prime rib per pound?

The USDA FSIS chart gives 23 to 30 minutes per pound for a bone-in rib roast of 4 to 8 pounds at 325 °F, and 39 to 43 minutes per pound for a 4 lb boneless rib roast.

What temperature should prime rib reach?

FSIS sets a minimum of 145 °F measured with a food thermometer before the roast leaves the oven, then a rest of at least 3 minutes. Higher temperatures are a matter of preference.

What oven temperature does the USDA recommend?

The chart uses 325 °F, and FSIS does not recommend cooking meat in ovens set lower than 325 °F.

Is the calculator accurate for a 10 lb roast?

The chart row stops at 8 lb for bone-in, so the tool warns that the result is a rougher guess outside 4 to 8 lb. Use the thermometer.

Do I count the rest in the cooking time?

No. The cooking range ends when the thermometer reads 145 °F or higher. The rest comes after, and the tool subtracts it when it works out your start time.

Can I use this for a boneless roast heavier than 4 lb?

The chart lists a boneless rib roast at 4 pounds only, so other weights are a rougher estimate. Use the thermometer.

Use a thermometer

Times are USDA planning estimates read on October 26, 2026. The roast is done when a food thermometer says so.