United States · Veterans benefits
VA combined rating.
Enter each service-connected rating and see how VA combines them, one step at a time. Ratings are not added together.
VA applies your largest rating first, then each next rating to the efficiency that remains, and rounds to the nearest 10 only once at the end. For example, 50% and 30% combine to 65%, which rounds up to 70%.
Your ratings
Tick “bilateral” for disabilities of both arms, both legs, or paired skeletal muscles. Two or more ticked ratings get the 10% bilateral factor.
Combined rating
How the working goes
- Sort ratings from largest to smallest.
- Combine the first two: the second rating applies only to the efficiency left after the first (60% then 40% is 60 + 40% of the remaining 40, which is 76).
- Combine that whole-number result with the next rating, and so on. Each step uses the whole number shown in VA’s Combined Ratings Table.
- Round the final value to the nearest 10; a final 5 rounds up.
- Bilateral: combine the paired ratings, add (not combine) 10% of that value, and treat the total as a single rating in the order of severity. If that would lower your result, 38 CFR 4.26(d) says the most favorable outcome is used, and this tool checks that too.
Official sources: 38 CFR 4.25, combined ratings table, 38 CFR 4.26, bilateral factor and VA: About disability ratings. The calculation was checked against every cell of the 4.25 table as published on eCFR on September 30, 2026.
Related: VA disability payment calendar.
Why 50% plus 30% is 70%, not 80%
VA does not add disability ratings. Its regulation treats each rating as a loss of efficiency, and each new rating applies only to the efficiency that is left. 38 CFR 4.25 explains it with a 60% disability: a person at 60% is considered 40% efficient. A further 30% disability then removes 30% of that remaining 40%, which is 12 points, leaving 28% efficiency, so the person is 72% disabled. The table in 4.25 is a lookup for exactly this arithmetic.
The same logic explains the order. You always begin with the largest rating and then work down. The result after each step is read from the Combined Ratings Table as a whole number and fed into the next step. Only the final figure is rounded to the nearest 10, with a final 5 rounding up. The regulation says this conversion is done only once per rating decision, after all disabilities are combined, and is the last procedure.
Worked examples you can check on the form
- 50% and 30%. Combined value 65%. Rounds to 70%. This is the example in 4.25(a).
- 40% and 20%. Combined value 52%. Rounds to 50%, also from 4.25(a).
- 60%, 40% and 20%. The first two combine to 76%. Combining 76% with 20% gives 81%. Rounds to 80%, as in 4.25(a).
- Three 30% ratings. 30% and 30% combine to 51%; 51% and 30% combine to 66%. Rounds to 70%. Three ratings of 30% are worth more than two, but less than their sum of 90%.
- Two 50% ratings. Combined value 75%, which rounds up to 80%, because a final 5 rounds upward.
Notice what the examples show. The more ratings you stack, the smaller the effect of each additional one, because each applies to a shrinking pool of remaining efficiency. A small 10% rating added to a 70% rating moves the combined value from 70 to 73 and rounds back to 70, so it changes nothing on its own. That is not a bug in the calculator; it is how rounding to the nearest 10 works.
The bilateral factor
38 CFR 4.26 applies when partial disabilities affect both arms, both legs or paired skeletal muscles. The ratings for the right and left sides are combined as usual, and then 10 percent of that value is added (not combined). The result is treated as a single disability for ordering and for every later combination. The bilateral factor applies only when there is a partial disability of compensable degree in each of two paired extremities or muscles. The regulation's own example uses 60%, 20%, 10% and 10%, where the two 10% ratings are bilateral: they combine to 19, plus 10 percent of that (1.9) makes 21, so the order of severity is 60, 21 and 20; 60 and 21 combine to 68, then 68 and 20 combine to 74, which converts to 70%. Tick the "bilateral" box on the two 10% rows to reproduce it.
Paragraph (d) of 4.26 adds a safeguard. If leaving one or more bilateral disabilities out of the factor gives a higher combined evaluation, they are removed from the factor and combined separately, so the most favourable result for the veteran is used. The tool checks both ways, which is why you may occasionally see a note that the factor was left out.
Common mistakes and edge cases
- Adding instead of combining. VA states on its disability ratings page that calculating a combined rating involves more than adding up individual ratings, which is why the combined rating can differ from the sum.
- Rounding at every step. Do not round intermediate results to 10. Use the whole-number value from the table at each step, then round once.
- Counting a bilateral pair as two separate ratings. Mark both ratings as bilateral so the factor is applied once to the pair.
- Entering the ratings of conditions that are not service-connected. Only service-connected ratings combine. A tool cannot tell which of your conditions VA has rated.
- Expecting a dollar amount. This page returns a percentage only. VA bases the monthly payment on the combined rating and on dependents, and publishes current compensation rates on its own rates page.
Who this is for, and what it does not cover
It is for veterans, family members and representatives who want to see the working behind a combined rating, check a letter, or understand how one more rating might change the total. It follows 38 CFR 4.25 and 4.26 only. It does not predict whether a claim will be approved, what percentage VA will assign to a condition, or how special provisions such as amputation rules, extremity combinations or special monthly compensation affect payment. For help with a claim, contact VA or an accredited representative. When you want to see payment dates, try the VA disability payment calendar.
Frequently asked questions
How does VA combine disability ratings?
VA starts with the highest rating, then applies each next rating to the efficiency that remains, reading each result from the Combined Ratings Table. Only the final value is rounded to the nearest 10, and a final 5 rounds up.
Why do my ratings not add up to the combined rating?
Each rating applies only to what is left after the previous one. A 60% rating leaves 40% efficiency, so a 30% rating takes 12 points of that, not 30, which gives 72% before rounding to 70%.
What is 50% and 30% combined?
Combined, 50% and 30% make 65%, which VA rounds up to 70%. The same example appears in 38 CFR 4.25.
What is the bilateral factor?
When disabilities affect both arms, both legs or paired skeletal muscles, the ratings for the two sides are combined, then 10 percent of that value is added and treated as one rating in the order of severity. Each side needs a compensable rating.
Does VA round each step or only the end?
Only the end. The regulation says conversion to the nearest degree divisible by 10 is done only once per rating decision, after all disabilities are combined, and is the last step.
Can a 10% rating change my combined rating?
Sometimes. A 10% rating added to a 70% combined value gives 73%, which still rounds to 70%, so it may change nothing alone. Several small ratings together can push the unrounded value over the next rounding boundary.
Does this calculator tell me my monthly VA payment?
No. It returns a percentage only. VA bases the monthly amount on the combined rating and your dependents, and publishes current rates on its compensation rates page.
Is this a decision on my claim?
No. It is an arithmetic illustration of the published rules. Only VA assigns your rating, and other provisions can affect the result.
Sources
Primary sources used for this page, each retrieved October 2026.
- 38 CFR 4.25, Combined ratings table (eCFR) (retrieved 2026-10) – efficiency method, rounding once, examples
- 38 CFR 4.26, Bilateral factor (eCFR) (retrieved 2026-10) – bilateral factor, example and favourable-result exception
- VA, About disability ratings (retrieved 2026-10) – combined rating is more than adding ratings
- VA, Current disability compensation rates (retrieved 2026-10) – payment depends on rating and dependents
Not a claim decision or legal advice
This is an arithmetic illustration of the published rules. It does not decide, predict or review any claim. Only VA assigns your combined rating, and other rules (for example extremity, amputation or special monthly compensation provisions) can affect your actual rating. For help with a claim, contact VA or an accredited representative.